Control

BD118

These simple application boards use firmware based on the familiar CTA88 remote control systems to implement a bi-directional control link.

CTA28 App. boards

The CTA88 chip is a simple encoder/decoder for use with ISM band telemetry modules. It permits a simple, one way wireless link to be established, for simple remote control applications, with a minimum of effort and no customer software input.

CTA88

8 bit Address - 8 bit Data encoder/decoder

CTA88 is an 8 bit address, 8 bit data encoder and decoder combined in a single IC. This device is intended to be used with ISM band telemetry modules and can be operated in either Encode or Decode mode.

CTA88 Remote Control Application Boards

The CTA88 chip is a simple encoder/decoder for use with ISM band telemetry modules. It permits a simple, one way wireless link to be established, for simple remote control applications, with a minimum of effort and no customer software input

CTR124

CTR124: 4 bit Address - 12 bit Data Encoder / Decoder

Control124 is a 4 bit address, 12 bit data encoder and decoder combined in a single IC. This device can operate in either Encode or Decode mode. It uses 1kbps differential Manchester bit balancing with preamble and checksum.

CTR44

CTR44: 4 bit Address - 4 bit Data Encoder / Decoder

Control44 is a 4 bit address, 4 bit data encoder and decoder combined in a single IC. This device can operate in either Encode or Decode mode. It uses 1kbps differential Manchester bit balancing with preamble and checksum.

CXR2

Multi channel 25kHz NBFM remote control Receiver

The CXT transmitter and CXR receiver modules offer a multi channel, low power, and reliable remote control data link

CXT2

Multi channel 25kHz NBFM remote control Transmitter

The CXT transmitter and CXR receiver modules offer a multi channel, low power, and reliable remote control data link

i9600

The I9600 is a 9600baud half-duplex serial modem controller suitable for use with wideband receivers, transmitters and transceivers. It takes care of preamble, synchronisation, bit balancing and error checking and enables a transparent radio data link to be established between radio devices.

KDEC

Code hopping receiver with up to 5 relay outputs

KDEC is designed to provide the user with a complete receiver interface for Radiometrix transmitters such as KTX2 and KFX2. No additional parts needed to implement a complete system suitable for applications requiring high security RF remote control.